GW INSTEK AFG-2225 DUAL-CHANNEL ARBITRARY FUNCTION GENERATOR

Key Features

  • Wide Frequency Ranges From 1μHz to 25MHz (sine/square wave)
  • 1 μHz Resolution in Full Range
  • Built-in Standard 120MSa/s, 10bit, 4k Points Arbitrary Waveform for Both Channels
  • True Dual-Channel Output, CH2 Provides the Same Characteristics as CH1
  • Couple, Tracking, Phase Operations of Dual Channel are Supported

SPECIFICATIONS DUAL-CHANNEL ARBITRARY FUNCTION GENERATOR

Waveforms: Sine, Square, Ramp, Pulse, Noise, ARB

Arbitrary Functions

Sample Rate: 120 MSa/s

Repetition Rate: 60 MHz

Waveform Length: 4k points

Amplitude Resolution: 10 bits

Non‐Volatile Memory: 4k points

Frequency Characteristics

+ Range

Sine, Square: 1uHz~25MHz

Ramp: 1MHz

+ Resolution: 1uHz

+ Accuracy

Stability: ±20 ppm

Aging: ±1 ppm, per 1 year

Tolerance: ≤1 mHz

Output Characteristics

+ Amplitude

Range: 1mVpp to 10 Vpp (into 50Ω)

2mVpp to 20 Vpp (open‐circuit)

1mVpp to 5 Vpp (into 50Ω) for 20MHz‐25MHz

2mVpp to 10 Vpp (open‐circuit) for 20MHz‐25MHz

Accuracy: ±2% of setting ±1 mVpp (at 1 kHz/into50Ω without DC offset )

Resolution: 1mV or 3 digits

Flatness: ±1% (0.1dB) ≤100kHz

±3% (0.3 dB) ≤5MHz

±5% (0.4 dB) ≤12MHz

±10%(0.9dB) ≤25MHz

(sine wave relative to 1kHz/into 50Ω)

Units: Vpp, Vrms, dBm

+ Offset

Range: ±5 Vpk ac +dc (into 50Ω)

±10Vpk ac +dc (Open circuit)

±2.5 Vpk ac +dc (into 50Ω) for 20MHz‐25MHz

±5Vpk ac +dc (Open circuit) for 20MHz‐25MHz

Accuracy: 2% of setting + 20mV+ 0.5% of amplitude

+ Waveform Output

Impedance: 50Ω typical (fixed); > 10MΩ (output disabled)

Protection: Short‐circuit protected. Overload relay automatically disables main output

Sine wave Characteristics GW Instek AFG-2225

Harmonic distortion: ≤‐55 dBc DC ~ 200kHz, Ampl > 0.1Vpp

≤‐50 dBc 200kHz ~ 1MHz, Ampl > 0.1Vpp

≤‐35 dBc 1MHz ~ 5MHz, Ampl > 0.1Vpp

≤‐30 dBc 5MHz ~ 25MHz, Ampl > 0.1Vpp

Square wave Characteristics 

Rise/Fall Time: ≤25ns at maximum output. (into 50 Ω load)

Overshoot: 5%

Asymmetry: 1% of period +5 ns

Variable Duty Cycle: 1.0% to 99.0% ≤100kHz

10% to 90% ≤ 1MHz

50% ≤ 25MHz

Ramp Characteristics

Linearity: < 0.1% of peak output

Variable Symmetry: 0% to 100% (0.1% Resolution)

Pulse Characteristics

Period: 40ns~2000s

Pulse Width: 20ns~1999.9s

Overshoot: <5%

Jitter: 20ppm +10ns

AM Modulation

Carrier Waveforms CH1: Sine, Square, Ramp, Pulse,Arb

Carrier Waveforms CH2: Sine, Square, Ramp, Pulse,Arb

Modulating Waveforms CH1: Sine, Square, Triangle, Upramp, Dnramp

Modulating Waveforms CH2: Sine, Square, Triangle, Upramp, Dnramp

Modulating Frequency CH1: 2mHz to 20kHz (Int); DC to 20kHz (Ext)

Modulating Frequency CH2: 2mHz to 20kHz (Int); DC to 20kHz (Ext)

Depth CH1: 0% to 120.0%

Depth CH2: 0% to 120.0%

Source CH1: Internal / External

Source CH2: Internal / External

FM Modulation 

Carrier Waveforms CH1: Sine, Square, Ramp,

Carrier Waveforms CH2: Sine, Square, Ramp,

Modulating Waveforms CH1: Sine, Square, Triangle, Upramp, Dnramp

Modulating Waveforms CH2: Sine, Square, Triangle, Upramp, Dnramp

Modulating Frequency CH1: 2mHz to 20kHz (Int); DC to 20kHz (Ext)

Modulating Frequency CH2: 2mHz to 20kHz (Int); DC to 20kHz (Ext)

Peak Deviation CH1: DC to Max Frequency

Peak Deviation CH2: DC to Max Frequency

Source CH1: Internal / External

Source CH2: Internal / External

Sweep GW Instek AFG-2225

Waveforms CH1: Sine, Square, Ramp,

Waveforms CH2: Sine, Square, Ramp,

Type CH1: Linear or Logarithmic

Type CH2: Linear or Logarithmic

Start/Stop Freq CH1: 1uHz to Max Frequency

Start/Stop Freq CH2: 1uHz to Max Frequency

Sweep Time CH1: 1ms to 500s

Sweep Time CH2: 1ms to 500s

Source CH1: Internal / External/Manual

Source CH2: Internal / External/Manual

FSK

Carrier Waveforms CH1: Sine, Square, Ramp, Pulse

Carrier Waveforms CH2: Sine, Square, Ramp, Pulse

Modulating Waveforms CH1: 50% duty cycle square

Modulating Waveforms CH2: 50% duty cycle square

Modulation Rate CH1: 2mHz to 100 kHz (INT) DC to 100 kHz(EXT)

Modulation Rate CH2: 2mHz to 100 kHz (INT) DC to 100 kHz(EXT)

Frequency Range CH1: 1uHz to Max Frequency

Frequency Range CH2: 1uHz to Max Frequency

Source CH1: Internal / External

Source CH2: Internal / External

PM

Carrier Waveforms CH1: Sine, Square, Ramp

Carrier Waveforms CH2: Sine, Square, Ramp

Modulating Waveforms CH1: Sine, Square, Triangle, Upramp, Dnramp

Modulating Waveforms CH2: Sine, Square, Triangle, Upramp, Dnramp

Modulation Frequency CH1: 2mHz to 20kHz (Int) DC to 20kHz (Ext)

Modulation Frequency CH2: 2mHz to 20kHz (Int) DC to 20kHz (Ext)

Phase deviation CH1: 0˚ to 360˚

Phase deviation CH2: 0˚ to 360˚

Source CH1: Internal / External

Source CH2: Internal / External

SUM 

Carrier Waveforms CH1: Sine, Square, Ramp, Pulse, Noise

Carrier Waveforms CH2: Sine, Square, Ramp, Pulse, Noise

Modulating Waveforms CH1: Sine, Square, Triangle, Upramp,Dnramp

Modulating Waveform CH2: Sine, Square, Triangle, Upramp,Dnramp

Modulation Frequency CH1: 2mHz to 20kHz (Int) DC to 20kHz (Ext)

Modulation Frequency CH2: 2mHz to 20kHz (Int)DC to 20kHz (Ext)

SUM Depth CH1: 0% to 100.0%

SUM Depth CH2: 0% to 100.0%

Source CH1: Internal / External

Source CH2:  Internal / External

External Trigger Input

Type: For FSK, Burst, Sweep

Input Level: TTL Compatibility

Slope: Rising or Falling(Selectable)

Pulse Width: >100ns

Input Impedance: 10kΩ,DC coupled

External Modulation Input

Type: For AM, FM, PM, SUM

Voltage Range: ±5V full scale

Input Impedance: 10kΩ

Frequency: DC to 20kHz

Trigger Output GW Instek AFG-2225

Type: For Burst, Sweep, Arb

Level: TTL Compatible into 50Ω

Pulse Width: >450ns

Maximum Rate: 1MHz

Fan‐out: ≥4 TTL Load

Impedance: 50Ω Typical

Dual Channel Function

Phase CH1: ‐180˚ ~180˚; Synchronize phase

Phase CH2: ‐180˚ ~ 180˚; Synchronize phase

Track CH1: CH2=CH1

Track CH2: CH1=CH2

Coupling CH1: Frequency(Ratio or Difference); Amplitude & DC Offset

Coupling CH2: Frequency(Ratio or Difference); Amplitude & DC Offset

DSOlink CH1:  √

DSOlink CH2:  √

Burst 

Waveforms CH1: Sine, Square, Ramp

Waveforms CH2: Sine, Square, Ramp

Frequency CH1: 1uHz~25MHz

Frequency CH2:  1uHz~25MHz

Burst Count CH1: 1 to 65535 cycles or Infinite

Burst Count CH2:  1 to 65535 cycles or Infinite

Start/Stop Phase CH1: ‐360 to +360

Start/Stop Phase CH2: ‐360 to +360

Internal Period CH1: 1ms to 500s

Internal Period CH2: 1ms to 500s

Gate Source CH1: External Trigger

Gate Source CH2: External Trigger

Trigger Source CH1: Single, External or Internal Rate

Trigger Source CH2: Single, External or Internal Rate

+ Trigger Delay

N‐Cycle, Infinite CH1: 0s to 655350ns

N‐Cycle, Infinite CH2: 0s to 655350ns

Frequency Counter GW Instek AFG-2225

Range: 5Hz to 150MHz

Accuracy: Time Base accuracy±1count

Time Base: ±20ppm (23˚C ±5˚C) after 30 minutes warm up

Resolution: The maximum resolution is: 100nHz for 1Hz, 0.1Hz for 100MHz.

Input Impedance: 1kΩ/1pf

Sensitivity: 35mVrms ~ 30Vms (5Hz to 150MHz)

Save/Recall: 10 Groups of Setting Memories

Interface: USB (Host & Device)

Display: 3.5”TFT LCD

General Specifications

Power Source: AC100~240V, 50~60Hz

Power Consumption: 25 W (Max)

Operating Environment: Temperature to satisfy the specification :  18 ~ 28˚C

Operating temperature : 0 ~ 40˚C

Relative Humidity: < 80%, 0 ~ 40˚C

Installation category: CAT II

Operating Altitude: 2000 Meters

Storage Temperature: ‐10~70˚C, Humidity: ≤70%

Dimensions (WxHxD): 266(W) x 107(H) x 293(D) mm

Weight: Approx. 2.5kg

Accessories: GTL‐101× 2; Quick Start Guide ×1; CD (user manual + software) ×1; Power cord×1

Introduction GW Instek AFG-2225

GW Instek is launching AFG-2225, its first basic level dual-channel arbitrary function generator, which provides superior features in its class.

The major features for both channels include 10Vpp output amplitude; 25MHz frequency bandwidth with 1uHz resolution; built-in waveforms of Sine, Square, Ramp (Triangle) and Noise. As to the 1%~99% adjustable duty cycle of Square waveform can be used as pulse signal sources. For the arbitrary waveform, user can edit the 66 built-in waveforms or create a whole new one. Moreover, AFG-2225 carries features of AM/FM/PM/FSK/SUM Modulation, Sweep, Burst and Frequency Counter, which can be applied to various communication fields.
In addition to the intuitive and friendly user interface, the 3.5-inch color LCD displays the comprehensive operation information including the true waveform presented at the output. USB Host and Device interfaces are equipped to link the AFG-2225 with other devices, which provide the flexibility of waveform generation for more practical usages. With link to GW Instek GDS-series Digital Storage Oscilloscopes (DSOs), the waveforms of interest can be captured and reconstructed. User can also use the arbitrary waveform PC software to edit the waveform and then send to AFG-2225 directly, or save the waveform into flash drive and then transfer to AFG-2225.

Features 

– Wide Frequency Ranges From 1μHz to 25MHz (sine/square wave)
– 1 μHz Resolution in Full Range
– Built-in Standard 120MSa/s, 10bit, 4k Points Arbitrary Waveform for Both Channels
– True Dual-Channel Output, CH2 Provides the Same Characteristics as CH1
– Couple, Tracking, Phase Operations of Dual Channel are Supported
– 1% ~ 99% Adjustable Duty Cycle for Square Waveform
– High Resolution and Colored TFT LCD with Friendly User Interface
– Multiple Editing methods to Edit Arbitrary Waveform Easily
– Built-in Standard AM/FM/PM/FSK/SUM/Sweep/Burst and Frequency Counter
– USB Host/Device Interface for Remote Control and Waveform Editing

Attribute

Brand

Review GW INSTEK AFG-2225 DUAL-CHANNEL ARBITRARY FUNCTION GENERATOR

5 0% | 0 review
4 0% | 0 review
3 0% | 0 review
2 0% | 0 review
1 0% | 0 review
Review GW INSTEK AFG-2225 DUAL-CHANNEL ARBITRARY FUNCTION GENERATOR
Choose a image
0 character ( Minimum of 10)
    +

    There are no reviews yet.

    No comments yet

    RECENT PRODUCT

    Hotline: 0908 173 345
    Zalo: 0908 173 345 Nhắn tin Facebook Gửi Mail