SPECIFICATIONS KYORITSU 2200 AC DIGITAL CLAMP METERS
±1.6%rdg±6dgt (45 – 65Hz)
±1.8%rdg±7dgt (45 – 65Hz)
±2.3%rdg±8dgt (65 – 500Hz)
±2.0%rdg±4dgt (0 – 400kΩ)
Continuity buzzer: buzzer sounds below 50±30Ω
Conductor size: Ø33mm max
CAT III 600V Pollution degree 2 (AC A),
CAT III 300V / CAT II 600V Pollution degree 2 (AC/DC V)
IEC 61010-031, IEC 61010-2-032, IEC 61326 (EMC)
R03/LR03 (AAA) (1.5V) × 2
*continuous measuring time:
approx. 350 hours (Auto power off: approx. 10 minutes)
Dimensions: 190(L) × 68(W) × 20(D) mm
Weight: Approx. 120g (including batteries)
Included Accessories: 7107A (Test leads), 9160 (Carrying case), R03 (AAA) × 2, Instruction Manual
Introduction Kyoritsu 2200
The Kyoritsu 2200 is a compact and lightweight digital multimeter, capable of measuring current up to 1000A AC, as well as AC and DC voltage. Comprised of a 33mm tear-drop jaw, the 2200 is perfect for use in tight working conditions.
The 2200 model by Kyoritsu – Japan is rated to 1000A AC, autoranging across three ranges of AC 40/400/1000A. Coupled with the DMM function, the Kyoritsu 2200 can also measure both AC and DC voltage as well as resistance. Additionally, the 2200 features a continuity buzzer, a data hold function and auto power-off to conserve battery life.
Complying to IEC61010-1 Safety Standard CAT III 600V (AC A) CAT III 300V / CAT II 600V (AC/DC V), the Kyoritsu 2200 also makes use of fuseless electronic protection up to 600V, allowing for safe operation. The portable design of the 2200 model makes it very easy to use and a valuable addition to any toolbox. Kyoritsu 2200 is the best of electrical measuring.
Features Kyoritsu 2200
– Ultra Slim and lightweight Handy design
– 1000A AC Clamp Meter AC40/400/1000A Auto Range
– Ø33mm Tear Drop Jaw easy to use in tight places
– DMM function ACV, DCV, Ω, Continuity Buzzer
– Fuseless electronic protection on up Ω/ to 600V
– IEC61010-1 Safety Standard
CAT III 600V (AC A) CAT III 300V / CAT II 600V (AC/DC V)
Primary electrical circuits of equipment connected to an AC electrical outlet by a power cord.
Primary electrical circuits of the equipment connected directly to the distribution panel, and feeders from the distribution panel to outlets.
The circuit from the service drop to the service entrance, and to the power meter and primary over current protection device(distribution panel).
Current measurement section of this instrument is designed for CAT III 600V and Voltage measurement section is for CAT III 300V / CAT II 600V respectively.
Test leads 7107A with the Cap is designed for CAT IV 600V / CAT III 1000V and without the Cap is for CAT II 1000V.