Technical ARC Plasma X5 Dual voltage

Our plasma X5 dual is our replacement model for the older technology Plasma 56i model.

The X5 dual outperforms the Plasma 56i in every way.

Good cutting performance combined with the lowest running costs possible & excellent reliability make this the ideal machine for light to medium duty cutting applications.

Ideal for cutting all metals even painted & rusty material.

Clean cutting up to 15mm (11mm on 110V supply).

Severance (very slow rough cut) up to 24mm (16mm on 110V supply).

230V single phase supply 13A/16A.

Standard features Technical ARC Plasma X5 Dual voltage

• Variable output power from a fine cut on foil right up to cutting thick plate.
• Cutting performance as good as the very best.
• Drag cut consumables for easy template following.
• Pilot arc fitted to pierce through paint & rust etc.
• Non HF air arc starting means safe for use on vehicles & near IT equipment.
• Genuine Trafimet S45 Italian torch fitted & quick connector on torch.
• Low cost torch consumables available in every part of the world.
• High duty cycle to cope with demanding applications.
• High efficiency low electric  consumption.
• Fan on demand circuit fitted so only runs when needed.
• 230V single phase 16A (13A up to 3/4 power) or 110V input.
• Generator friendly.
• Engineer friendly (these machines can easily be maintained).

Built to comply with BS EN 60974-1, CE marked, RoHS compliant and WEEE registered so you can be sure of the safety & quality.

Options

Longer torch.

Circle cutting kit.

Extended torch consumables to get into tight spaces.

We guarantee to fully support these models with spares & service for a minimum of 10 years.

The best back up in the industry!